Engraving speed could be as high as 3000MM/Min.
Laser power range could be S0 – S1000, compared to 8bits desktop laser engravers, which only has S0 – S255, Ortur Laser Master could control laser beam more accurately, could even use the high power laser unit to “draw” a picture on paper, that the 8bits high power laser engravers could not do.Ortur laser master firmware, smarter, faster, higher precision and easier to use. The Most Advanced 32Bits Laser Engraver Firmware.It could preprocess 32 instructions, support baud rate as high as 921600, more powerful! The Laser Master 2 – 20W is higher power and supports a faster engraving and cutting.
The Laser Master 2 – 15W is the most cost-effective, available for both engraving and light cutting.The Laser Master 2 – 7W is good at picture engraving.This board does not offer control of power through software – we recommend upgrading the board to take full advantage of LightBurn. Please note that LightBurn does not support the stock M2-Nano board in the popular K40 laser.
If it doesn’t work, sometimes it only takes a day or two to make the required changes to support a new board in these existing families. If your controller is GCode, Ruida, Trocen, or TopWisdom based, even if it’s not listed it might be supported already – Download the free trial and try it for yourself. More controllers will be added soon, so if you don’t see yours listed, send us a message – maybe we’re already working on it! Supported Trocen controllers include the AWC708C, AWC608, and TL-3120. Supported Ruida controllers include the RDC6442G/S, RDC6445G, RDC6332G, RDLC-320A, and R5-DSP. Supported GCode controllers,include Grbl, Smoothieware, Grbl-LPC, and Marlin. We currently support most Ruida, Trocen, TopWisdom, and GCode based controllers. LightBurn talks directly to your laser, without the use of additional software.
0 kommentar(er)
